mathcad microsoft equation 3.0 error message

A shame because the prvious version 2.0 was working flawlessly.

As a last resot Can I just simply disable WSUS?. In either case I can't find anywhere in the admin console or the WSUS console that elaborated on this error.ĭoes anyone have any idea how I should start to try and diagnose this problem, or why it might be occuring. (or at least that what I think the situation is by looking at the updates screen). (Screenshots of Mathcad-Template included as appendix. Maybe somebody here can see, what I'm doing wrong. The problem is, that I'm still getting results for E11 that are nowhere near the expected value. I had previously ran WSUS 2.0 on SBS with four client machines for a couple of months with no issues whatsoever, I can't seem to dig up any other error information relating to this besides the message above taken fromt he SBS event log.įor some reason WSUS 3.0 lists updates even if they have been superseded by a newer version of the same update (no idea why) so this 25% error actually seems to only refers to one update, except that update has a about 10 superseded versions and 1 current version. I checked all the equations multiple times and had them double checked by someone else - there seems to be no mistake. 'Client computers are installing updates with a higher than 25 percent failure rate'. I followed all the installation instructions to the tee yet no sooner had I installed it I start getting the following error:

List of fluids List of predefined mixtures GERG-2008 Equation of. I recently upgraded to WSUS 3.0 from 2.0. Convergence Failures and Forcing Phase Calculations Mixture Error Messages.

Mathcad microsoft equation 3.0 error message